Uploaded October 2023 | Updated September 2026, 1 week ago
Seems like this is a bust! ADXL did not increase with the lower motor. Need to test some prints to see if any better.
This is a Sherpa micro,, mini bolt pattern, modded to lower the motor ~20mm to lower the COM to test to see if ADXL increased. It didn't! Extruder is just a test to see.. Will mod the Vzhextrudort rear plate(make new one) to lower it ~20mm in the future.
Even though the ADXL vibration tests is not better it may perform better? Seems a lower motor would help!
Seems like this is a bust! ADXL did not increase with the lower motor. Need to test some prints to see if any better.
This is a Sherpa micro,, mini bolt pattern, modded to lower the motor ~20mm to lower the COM to test to see if ADXL increased. It didn't! Extruder is just a test to see.. Will mod the Vzhextrudort rear plate(make new one) to lower it ~20mm in the future.
Even though the ADXL vibration tests is not better it may perform better? Seems a lower motor would help!
