Uploaded November 2024 | Updated September 2026, 1 week ago
Finished the motor mounts, put the belts on to check alignment, dressed some of the plates.
Need to check alignment again to make sure the height is right on the cross standoffs, belts and motor mounts are done. Had to re-do some plates.... Tough, time consuming job. The hard part is done, so should be down hill from here.
All the parts were made with common hand tools with the exception of the SLM printed worm extruder.
Finished the motor mounts, put the belts on to check alignment, dressed some of the plates.
Need to check alignment again to make sure the height is right on the cross standoffs, belts and motor mounts are done. Had to re-do some plates.... Tough, time consuming job. The hard part is done, so should be down hill from here.
All the parts were made with common hand tools with the exception of the SLM printed worm extruder.
