FPV Big Rock 3s Sensored Roaming @Magneticitist
FPV Big Rock 3s Sensored Roaming  @Magneticitist
Uploaded January 2024 | Updated November 2026, 3 hours ago
Did all this testing on this rig after first building it just to do a couple decent longer range runs, and now I'm back to testing all over again after upgrades. Here's a 25 min run on various terrain with the Copperhead 10 and Hobbywing 2400Kv motor. To make it work sensored you need an adapter or just splice the sensor wires yourself. That ESC can data-log so I can look up what the ESC temps were reaching during any of the runs. It maxed at about 87 degrees so maybe I can make the Kaiju tires work. An example of where the all-stock setup would have ran into trouble is when I rammed into a deep pile of leaves trying to get up a curb. Even the sensored setup just barely made it out so it probably would have just got stuck cogging all stock. The Kaiju tires would have just ate it, but maybe would have worked the ESC too hard with the stock pinion. I'm about to throw a 13T pinion on there anyway just to be sure, then give the Kaijus a good run.
I'm also adding a 3200Kv sensored motor and ESC combo to my 3s Typhon along with a 17T pinion gear to see if I can hit a consistent 60mph with it and also maintain safe temperature levels on all terrain. If that works out the only thing I might need to upgrade after that is the tires. It should be something I could get on a main road with and actually beat traffic if I needed to. Over 60mph is probably just asking to have it hulk smashed.

Another interesting option out there is FOC ESC/Motor combos which are offered by Hobbywing. Field Oriented Control is another name for Open-Loop Vector or Sensorless Vector control which is often used in 3 phase induction motors. It should be basically all around better than square wave control. While Hobbywing didn't invent it they seem to be the only ones I can see offering it as a control method. They offer it for 540 spec motors to be used in rock crawlers though, so going sensored is my only option for better control in the bashers.


Things to consider:
-When upgrading the motor you have to make sure the mounting holes will line up, and that you have the right shaft diameter for your pinion gear. (5mm safe-D for Big Rock and Typhon)
-When upgrading the pinion you need to match the teeth pitch on the spur gear, which in my case is '0.8 Mod' for both cars.
-Increasing the gearing is going to heat everything more but increase top speed
-Decreasing the gearing will heat everything less and decrease top speed
-Increasing motor Kv will increase max RPMs and at-speed torque along with max loaded current
-Decreasing motor Kv will decrease max RPMs and at-speed torque via lower currents but briefly increase starting torque
-Increasing tire size even a little bit will put a lot more stress on the drivetrain and electronics
-Sensored-only setups may more efficiently start/punch from stop even through resistance, but may run less efficient than a brushless-only drive overall.
-Not all motors of the same Kv rating have the same no-load current rating (current draw of motor at rated RPM's with free spinning unloaded shaft)
-The actual real peak power at-ready in your rig is going to depend on not just the ESC and motor (or quality of drivetrain etc..) but the C rating of your batteries and the resistance of your power wiring. Big capacitors+high C rated Lipos, thick+short wires, and good connectors are going to show an improvement in things like top speed runs.
-No "Punch" regulation means that the ability of your rig to power through a resistance from a dead stop will depend on how much amperage the battery can provide, up to the point where the electronics can take it without overheating. Unsuccessfully trying to power through resistance from a dead stop for too long would almost definitely overheat if not kill something. An ESC-provided regulation setting can help prevent that.
FPV Big Rock 3s Sensored Roaming1.3ghz AV RC Car FPV Test w/2.4ghz Control~2W Mini Isolated DC to DC Converter (Common Push-Pull TL494 + 2N2222 + BD139)RC FPV DJI O3 Rainy Day TestsRC FPV Park Roam (DJI O3 + Crossfire + 1.3G Audio)HEQ G-Port Gimbal + DJI O4 Pro Test (Fireteam 6s)Typhon 3s FPV DJI 03 + 1280Mhz Audio (Lawmate RX Test)Walksnail Avatar GT vs DJI O3 Test 2 (Ground Level)11Mhz SiC HFSSTC w/GlassTyphon 3s FPV Small Park StrollMore Plasma Toroid Testing (mystery gas mixture)RC FPV O3 Air Unit Exploring (Goggles Feed)
Magneticitist |

FPV Big Rock 3s Sensored Roaming

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER