Uploaded January 2023 | Updated September 2026, 3 days ago

---

#shorts
I wanted to make some leather bookmarks for my book club friends. I created some artwork and used the Lightburn software to laser engrave the leather. I used painters tape to remove the soot.

Here are the things I used:
* XTOOL 20W Laser cutter/engraver ( amzn.to/3C1O3CM )
* XTOOL Honeycomb bed ( amzn.to/3I2ZduL )
* XTOOL Air Assist ( amzn.to/3Gok22s )
* XTOOL RA2 Rotation Stage ( amzn.to/3QwKw5l )
* Neodymium magnets ( amzn.to/3Q0xEnR )
* Lightburn Software ( amzn.to/3WRytln )
* Leather bookmark blanks ( amzn.to/3JaV34T )
* Painters tape ( amzn.to/3W4qAbm )

FTC Disclaimer: We may earn commissions for purchases made through the links below. As Amazon Associates we earn from qualifying purchases.