Uploaded December 2024 | Updated November 2026, 1 day ago
Goggles V2 footage of what I see when driving.
This is the 2nd HEQ Gimbal I'm testing out after deciding I want the butter smooth view on my Typhon. This one had all the same initial problems I was expecting so I went ahead and added the 3 penny counterweight to the back and upped the torque settings. This time I think I'm going 15000 pitch, 15000 roll, and 25000 yaw and I'm able to leave the FPV mode locked instead of just temporarily triggering it on with a momentary function. When the one on the Big Rock is left in FPV mode HIGH then it vibrates. By just temp triggering it there is no vibration and the yaw stays locked until next power down but the movement speed does not increase to what it's supposed to be in FPV mode. This one doesn't have that problem.
These rigs also have a lot going on in terms of wiring so I was noticing a lot of noise jitter in the gimbal on the first test before I cleaned up the signal paths some. I think a clean rig with good settings will work almost perfectly. I'm totally fine with how this is working on the Typhon though and it's definitely much easier to drive fast with clear visibility on almost any surface. The C20-T gimbal looks like a promising alternative but to me it appears similar to the Caddx GM3 (for Walksnail). The GM3 offers out of the box usability without any settings or upgrades or extra control channels but you'll be dealing with a 3 axis follow that has a little bit of stabilizing (all 3 axes will be loosely locked from factory). If you add 2 extra control channels to switch modes and change the sensitivity I can see it working pretty good. You would need a controller with enough knobs and toggles though.
Goggles V2 footage of what I see when driving.
This is the 2nd HEQ Gimbal I'm testing out after deciding I want the butter smooth view on my Typhon. This one had all the same initial problems I was expecting so I went ahead and added the 3 penny counterweight to the back and upped the torque settings. This time I think I'm going 15000 pitch, 15000 roll, and 25000 yaw and I'm able to leave the FPV mode locked instead of just temporarily triggering it on with a momentary function. When the one on the Big Rock is left in FPV mode HIGH then it vibrates. By just temp triggering it there is no vibration and the yaw stays locked until next power down but the movement speed does not increase to what it's supposed to be in FPV mode. This one doesn't have that problem.
These rigs also have a lot going on in terms of wiring so I was noticing a lot of noise jitter in the gimbal on the first test before I cleaned up the signal paths some. I think a clean rig with good settings will work almost perfectly. I'm totally fine with how this is working on the Typhon though and it's definitely much easier to drive fast with clear visibility on almost any surface. The C20-T gimbal looks like a promising alternative but to me it appears similar to the Caddx GM3 (for Walksnail). The GM3 offers out of the box usability without any settings or upgrades or extra control channels but you'll be dealing with a 3 axis follow that has a little bit of stabilizing (all 3 axes will be loosely locked from factory). If you add 2 extra control channels to switch modes and change the sensitivity I can see it working pretty good. You would need a controller with enough knobs and toggles though.










