Uploaded June 2024 | Updated November 2026, 3 hours ago
I'm going to set up my HyperGo 1/16 with a more sturdy rig that I can flip around no problem. It's just a single axis servo gimbal now with front and rear cams. To save battery I used a DPDT relay to switch power and signal between cameras instead of just the signal wires. This prevents an instant clean switch but I'd rather do it that way than possibly stress the VTX's 5v supply trying to power 2 cams at the same time (since it's like 90+ degrees now).
The video is coming from the DVR on skyzone goggles and it's using the 2 modules at the same time for 4 antennas. I have 2 patches and 2 omnis.
So far the best setup I have found is using Lumenier double AXII's on the receiver and the TrueRC Matchstick on the transmitter.
I'm going to set up my HyperGo 1/16 with a more sturdy rig that I can flip around no problem. It's just a single axis servo gimbal now with front and rear cams. To save battery I used a DPDT relay to switch power and signal between cameras instead of just the signal wires. This prevents an instant clean switch but I'd rather do it that way than possibly stress the VTX's 5v supply trying to power 2 cams at the same time (since it's like 90+ degrees now).
The video is coming from the DVR on skyzone goggles and it's using the 2 modules at the same time for 4 antennas. I have 2 patches and 2 omnis.
So far the best setup I have found is using Lumenier double AXII's on the receiver and the TrueRC Matchstick on the transmitter.










