Uploaded April 2024 | Updated November 2026, 1 day ago
So far not a success like I was hoping but I guess I can't be mad cause it does actually work for the most part. Probably should be testing this driver out on a smaller bridge or at a much lower frequency. I just need to figure out if there is some issue with the driver or it's just not cutting it with this full bridge at ~300khz.
I think first I'll try replacing the bricks with the minibloc bridge and see what happens. If it still seems to run crappy I'll have to start messing with the driver circuit. I can also try to steal a larger coil I have which might run at about half the frequency. There is also a chance I just need to shield everything better and solve the mystery popping problem and then just crank the voltage up a lot higher.
Not really sure why streaking was becoming such a big issue at times since the coupling is pretty loose and it's just running regular single resonance with secondary feedback. I know interference is a problem though because I grounded out my OCD input and it will still trigger if I set the pot too low.
So far not a success like I was hoping but I guess I can't be mad cause it does actually work for the most part. Probably should be testing this driver out on a smaller bridge or at a much lower frequency. I just need to figure out if there is some issue with the driver or it's just not cutting it with this full bridge at ~300khz.
I think first I'll try replacing the bricks with the minibloc bridge and see what happens. If it still seems to run crappy I'll have to start messing with the driver circuit. I can also try to steal a larger coil I have which might run at about half the frequency. There is also a chance I just need to shield everything better and solve the mystery popping problem and then just crank the voltage up a lot higher.
Not really sure why streaking was becoming such a big issue at times since the coupling is pretty loose and it's just running regular single resonance with secondary feedback. I know interference is a problem though because I grounded out my OCD input and it will still trigger if I set the pot too low.










