Uploaded November 2024 | Updated November 2026, 3 hours ago
4 iterations of Steve's circuits I've shown now where they are all basically going off the general values of the coils and using the recommended SMD capacitors (Wardpowerelectronics.com). This is pretty handy because I'm pretty familiar with those dimensions from previous circuits. I had several 75-100pF small doorknob caps so I basically have a bunch of these plasma flame builds now. I can say that if you stick to these general values then you shouldn't have too much trouble getting one of these to work at several hundred watts or more. Now over time I'll be messing with each of these to see if I can tune them better etc.
I'm not 100% sure what was going on when using the MLCC's as the resonant caps but it's either the general design of how I soldered them, or they are just too badass and the circuit couldn't handle the initial oscillation current. That immediate failure was twice on the same circuit and one more time on a different circuit. The other problem could have been using a double sided copper clad board and having the caps sitting right next to the coil.
I found that just building it so that the coupling of the secondary could be easily adjusted, it helps allow for wider voltage ranges without losing
the switching too much. Maybe that is a lazy solution for wanting to run it at 50V or less relative to 100V or above, and still being able to maintain switching that will avoid a lot of mosfet heating at the time.
4 iterations of Steve's circuits I've shown now where they are all basically going off the general values of the coils and using the recommended SMD capacitors (Wardpowerelectronics.com). This is pretty handy because I'm pretty familiar with those dimensions from previous circuits. I had several 75-100pF small doorknob caps so I basically have a bunch of these plasma flame builds now. I can say that if you stick to these general values then you shouldn't have too much trouble getting one of these to work at several hundred watts or more. Now over time I'll be messing with each of these to see if I can tune them better etc.
I'm not 100% sure what was going on when using the MLCC's as the resonant caps but it's either the general design of how I soldered them, or they are just too badass and the circuit couldn't handle the initial oscillation current. That immediate failure was twice on the same circuit and one more time on a different circuit. The other problem could have been using a double sided copper clad board and having the caps sitting right next to the coil.
I found that just building it so that the coupling of the secondary could be easily adjusted, it helps allow for wider voltage ranges without losing
the switching too much. Maybe that is a lazy solution for wanting to run it at 50V or less relative to 100V or above, and still being able to maintain switching that will avoid a lot of mosfet heating at the time.










