Uploaded July 2023 | Updated November 2026, 3 hours ago
I had to show the O3 footage with stabilization on the first run because the goggles footage was too shaky. This time the suspension isn't perfect and it's still going to shake around but minus the little micro-rattles I can easily track what's going on while moving at high speed. Stabilizing it now should have it looking really good. The first video is using the Osprey antenna which I thought worked pretty good. It definitely wasn't any worse than the stocks so I'll keep them since they stick out higher. For being so cheap I can recommend it as an O3 antenna combined with 2 CP stubbies and patches on the bottom. The second video is a reliable test where making it around the 130 meter long building always brings the video down into a blurry low bitrate at the most obstructed point using the stock antennas. I don't think the Osprey antennas would perform much better in that situation but would probably work better a little further out. Hugging alongside a building in between bushes is hard on signal but it still manages it well for linears.
RMRC makes the only reliable vtx I know of for 1.3g.. the others have horrible sinking where the outer shell is just going to prevent a fan from doing anything. With the RMRC I had basically 0 breakup in the audio feed combined with the 5.8g DJI and 915mhz Crossfire and it makes all the difference in driving around. Even with notch filters I had a lot of interference using the other cheap 1.2g transmitters. Small lm386 boards + electret with adjustable gain work well for the audio input. Matching TrueRC singularity antennas work the best for a small setup. The recorded audio is done through a runcam thumb and it's just set to autorecord when powered, and powers on when the O3 is switched. The live audio microphone is hearing more of what's going on outside the car and the runcam is hearing more of inside the car.
I had to show the O3 footage with stabilization on the first run because the goggles footage was too shaky. This time the suspension isn't perfect and it's still going to shake around but minus the little micro-rattles I can easily track what's going on while moving at high speed. Stabilizing it now should have it looking really good. The first video is using the Osprey antenna which I thought worked pretty good. It definitely wasn't any worse than the stocks so I'll keep them since they stick out higher. For being so cheap I can recommend it as an O3 antenna combined with 2 CP stubbies and patches on the bottom. The second video is a reliable test where making it around the 130 meter long building always brings the video down into a blurry low bitrate at the most obstructed point using the stock antennas. I don't think the Osprey antennas would perform much better in that situation but would probably work better a little further out. Hugging alongside a building in between bushes is hard on signal but it still manages it well for linears.
RMRC makes the only reliable vtx I know of for 1.3g.. the others have horrible sinking where the outer shell is just going to prevent a fan from doing anything. With the RMRC I had basically 0 breakup in the audio feed combined with the 5.8g DJI and 915mhz Crossfire and it makes all the difference in driving around. Even with notch filters I had a lot of interference using the other cheap 1.2g transmitters. Small lm386 boards + electret with adjustable gain work well for the audio input. Matching TrueRC singularity antennas work the best for a small setup. The recorded audio is done through a runcam thumb and it's just set to autorecord when powered, and powers on when the O3 is switched. The live audio microphone is hearing more of what's going on outside the car and the runcam is hearing more of inside the car.










