Uploaded February 2026 | Updated November 2026, 3 hours ago
This is the bridge and driver I made using the UCC21530 and SN74LV4046A.
I also have a 74HC14 to clean up a CT feedback signal before sending the non inverted output to SIGIN on the 4046. VCO out back to 2 more 74HC14 inputs, then back out as complimentary push pull signals to the UCC21530.
Using PC1 can work very good and I've always used it most of the time, but it does not create a true phase lock.
PC2 seems to lock fairly well so far with I guess the downside being that whatever kind of actual phase relation it ends up with while thinking it's holding 0 degrees, that might not be closer to the highest resonance at a particular time than what PC1 would be running at. It also seems to just drop right out a little easier to me than PC1, but at least it makes awesome sounds when it does it.
When using PC1 my loop filter consisted of 10K and 2nF and a 2nF timing cap. This allowed for a tiny adjustment window on the center frequency if desired and a wide operating range up to 2-3mhz.
When using PC2 I increased it to 10K and ~8nF as well as increasing the oscillator timing cap to 5nF. I wanted a lower top end and wider center frequency window.
I don't think I can really get any of the arcs I was wanting without running around 3mhz, but I'd want to interrupt it. If I can get good PC2 feedback with the smaller ~1mhz coils then maybe I can see whether it still works ok interrupted.
This is the bridge and driver I made using the UCC21530 and SN74LV4046A.
I also have a 74HC14 to clean up a CT feedback signal before sending the non inverted output to SIGIN on the 4046. VCO out back to 2 more 74HC14 inputs, then back out as complimentary push pull signals to the UCC21530.
Using PC1 can work very good and I've always used it most of the time, but it does not create a true phase lock.
PC2 seems to lock fairly well so far with I guess the downside being that whatever kind of actual phase relation it ends up with while thinking it's holding 0 degrees, that might not be closer to the highest resonance at a particular time than what PC1 would be running at. It also seems to just drop right out a little easier to me than PC1, but at least it makes awesome sounds when it does it.
When using PC1 my loop filter consisted of 10K and 2nF and a 2nF timing cap. This allowed for a tiny adjustment window on the center frequency if desired and a wide operating range up to 2-3mhz.
When using PC2 I increased it to 10K and ~8nF as well as increasing the oscillator timing cap to 5nF. I wanted a lower top end and wider center frequency window.
I don't think I can really get any of the arcs I was wanting without running around 3mhz, but I'd want to interrupt it. If I can get good PC2 feedback with the smaller ~1mhz coils then maybe I can see whether it still works ok interrupted.










