Uploaded November 2024 | Updated November 2026, 3 hours ago
I killed my other 1200V fets by not noticing my resonant caps were destroyed, probably when I soldered them, so I went back to this 75pF doorknob even though I needed 100pF instead. I'm using the *UJ4C0750334KS fet now (oops I read it totally wrong off the package first, now corrected). I'm using the same general dimensions as Steve's circuit for the LC but have the 75pF cap and the primary is 7 turns instead of 6. The secondary is about 40 turns of 24AWG on a 1.25" former.
I started with 100pF Cds, 14nF Cgs, and 4.7ohm series gate resistance.
I ended up with no external Cds, 5nF Cgs, and the same 4.7ohms which I might increase a little. From there playing with the coupling helped me get it to switch nicely at 60VDC but it's still not quite pulling enough current. I'll need to add a few more nF on the gate then decrease the coupling a bit more, then hopefully this will put me in a region where I can hit about 400W at 60V and still have room to push 100V or so.
I killed my other 1200V fets by not noticing my resonant caps were destroyed, probably when I soldered them, so I went back to this 75pF doorknob even though I needed 100pF instead. I'm using the *UJ4C0750334KS fet now (oops I read it totally wrong off the package first, now corrected). I'm using the same general dimensions as Steve's circuit for the LC but have the 75pF cap and the primary is 7 turns instead of 6. The secondary is about 40 turns of 24AWG on a 1.25" former.
I started with 100pF Cds, 14nF Cgs, and 4.7ohm series gate resistance.
I ended up with no external Cds, 5nF Cgs, and the same 4.7ohms which I might increase a little. From there playing with the coupling helped me get it to switch nicely at 60VDC but it's still not quite pulling enough current. I'll need to add a few more nF on the gate then decrease the coupling a bit more, then hopefully this will put me in a region where I can hit about 400W at 60V and still have room to push 100V or so.










