Uploaded October 2024 | Updated November 2026, 3 hours ago
I'll end up using Brian's approach eventually since he has already run tested it successfully for a while but for now I'm just playing around with it. Brian also pointed me to some awesome resonant caps I can put cooling blocks on so I have one of those coming. It's better to take this approach the same way I've done with other PLL drivers where I'm just adding a PLL feedback into a schmitt trigger feedback circuit that uses a flip flop. Basically Steve Ward's DRSSTC 1 driver with OCD with the difference being that it's not using an interrupter and always running in continuous wave unless being current limited. In my case that basically causes the current limiting to do more of a noisy 60khz chopping instead of one modulated with interrupter pulses at much lower frequency and limited on time. The amps go way down and the tank is limited but it still pulls something like 20% power switching erratically.
I'll end up using Brian's approach eventually since he has already run tested it successfully for a while but for now I'm just playing around with it. Brian also pointed me to some awesome resonant caps I can put cooling blocks on so I have one of those coming. It's better to take this approach the same way I've done with other PLL drivers where I'm just adding a PLL feedback into a schmitt trigger feedback circuit that uses a flip flop. Basically Steve Ward's DRSSTC 1 driver with OCD with the difference being that it's not using an interrupter and always running in continuous wave unless being current limited. In my case that basically causes the current limiting to do more of a noisy 60khz chopping instead of one modulated with interrupter pulses at much lower frequency and limited on time. The amps go way down and the tank is limited but it still pulls something like 20% power switching erratically.










