QCW SSTC Double Full Bridge First Test @Magneticitist
QCW SSTC Double Full Bridge First Test  @Magneticitist
Uploaded March 2023 | Updated November 2026, 3 hours ago
After some troubleshooting the feedback I was able to basically recreate the same setup I've been testing but using this different driver and bridge. Maybe there's an obvious explanation I'm forgetting but regular feedback using any CT I tried would not work properly and give poor output until driving it at fixed frequency or PLL feedback. So far it seems to tune and perform the same if not a little better but I'm not yet making this bigger setup worthwhile until I see way bigger arcs.
What I don't like are the slow transitions despite decent switching waveforms so I might end up feeding the IXDN614's 24VDC and then use a step down ratio on the GDT to see if it improves. The 2 UCC chips by themselves would likely not be able to handle driving this bridge at 400-500khz without extremely low overall on times.

Since I now know that a single full bridge of the 60N65's can do pretty well, this 2x bridge should be able to handle some considerable power. Right now my main concern is still having no isolation or shielding but that's not really something I'm trying to do til I'm done tinkering with it.

After putting the driver inside an enclosure and cleaning things up I'll be further testing this as an SSTC at higher voltages, and if it survives I'll then switch over to the other coil and start winding a primary... Then I can start testing the operation with primary feedback and sourcing a good MMC. There still seems to be a lot of promise in just keeping it simple with secondary feedback and a tuned primary series capacitor.

Currently this build is as follows:

Finn Hammer's Arduino Ramp Generator
Steve Wards DRSSTC 1 w/OCD driver (w/added IXDN614YI's and PLL feedback)
8x FGA60N65SMD IGBT's in a full bridge + 20uF 600V smoothing
~12,000uF Bus capacitance for Buck Converter (3x 400V 4300uF)
15V Gate Drive from 5A switching regulator
200A IGBT Brick and 75A UF rectifier Buck w/T300-2D core @ about 150uH + 20uF capacitor for the LC (Similar to Loneoceans build)
Buck drive via single UCC27322 at 15V
Single 1:1 GDT
~400khz secondary 36AWG
QCW SSTC Double Full Bridge First TestBasic Arduino Nano Tesla Coil Interrupter V1 w/ Fiber Optic Link (SSTC/DRSSTC/Bluetooth Audio)Plasma Donut + PWM14Mhz Plasma Flame Build (for Plasma Toroid testing)RC FPV ARRMA Fireteam 4S DJI O4 Pro Tearing Up SnowQCWSSTC Box 16V (4S LiPo)Simple DIY Horn for RC Cars (NE555)RC FPV DJI O3 Air Unit w/RockSteady On Grass (no audio)H-Bridge Induction Heater Alu Nug ~600WTyphon 3s FPV Lot SurfingQCWSSTC Test w/3 Phase Brick ModuleQCWSSTC Miniblocs Test 300khz 100VDC
Magneticitist |

QCW SSTC Double Full Bridge First Test

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER