Uploaded March 2026 | Updated November 2026, 3 hours ago
Seen a few of these modules before and they probably have some cheapish ones on aliexpress. This one is actually only 25A and 50A pulsed. Doesn't really save much space but it's easier on the wiring. Might just run this one full wave CW since it can do it at 400khz or higher. Before that I might try to see how high I can bring the ramped arcs. Next thing I'll have to finish is the smaller buck starting at around 2200uF. The idea here is that I'm not exceeding 150VDC or so in the bus, which means when trying to build the "smaller" buck on the front, something like 200V caps could be used for just slightly longer arcs. A 200V even up to 10,000uf or so bus can be made pretty small.
The driver just runs the CT feedback through the 74HC14 then the 4046, then back to the 74HC14 for inverted and non inverter signals. Enable gating is done via a pullup on pin 5 Inhibit for an active high. CW around 400khz chugs around 22W gate drive at 18V bipolar on this bridge. Brute forcing the ramps at random tuning on a random SSTC circuit once again seems to produce promising arcs to where the ballpark of 1-2ft or even more seems pretty easy on a basic QCWSSTC, and much longer arcs is where I guess it takes that special something.
These bricks come with a gel inside and it's delicious.
Seen a few of these modules before and they probably have some cheapish ones on aliexpress. This one is actually only 25A and 50A pulsed. Doesn't really save much space but it's easier on the wiring. Might just run this one full wave CW since it can do it at 400khz or higher. Before that I might try to see how high I can bring the ramped arcs. Next thing I'll have to finish is the smaller buck starting at around 2200uF. The idea here is that I'm not exceeding 150VDC or so in the bus, which means when trying to build the "smaller" buck on the front, something like 200V caps could be used for just slightly longer arcs. A 200V even up to 10,000uf or so bus can be made pretty small.
The driver just runs the CT feedback through the 74HC14 then the 4046, then back to the 74HC14 for inverted and non inverter signals. Enable gating is done via a pullup on pin 5 Inhibit for an active high. CW around 400khz chugs around 22W gate drive at 18V bipolar on this bridge. Brute forcing the ramps at random tuning on a random SSTC circuit once again seems to produce promising arcs to where the ballpark of 1-2ft or even more seems pretty easy on a basic QCWSSTC, and much longer arcs is where I guess it takes that special something.
These bricks come with a gel inside and it's delicious.










