Half Bridge Flyback/TC Driver 20-200khz @Magneticitist
Half Bridge Flyback/TC Driver 20-200khz  @Magneticitist
Uploaded November 2024 | Updated November 2026, 2 days ago
This is basically just a screw-around bridge that just has a driver I can jumper between schmitt trigger feedback and variable frequency drive.
An old single phase 120VAC VFD is a good foundation for the power section.

-1400V 150A IGBT Brick
-100A 3p full wave rectifier module
-2x 200V 3000uF caps for doubler
-2x UCC2732_ gate drivers and GDT (I like to use T37 cores like B64290L0647X037)
-TL494 set for 50% duty and 22khz-200khz operation.

I believe the TL494 frequency range was easy to trim by placing a particular value resistor across the frequency potentiometer to limit the max resistance it could reach. To go well below 20khz you first need to make sure your GDT can pass that low of a frequency properly, and your actual flyback core won't saturate at the voltages you're driving the primary. I found staying above 20khz to be pretty reasonable. I should also be able to drive a Tesla Coil with this so long as the secondary is under 200khz or so.

Got too many random bricks I need to do something with so I figured I'd try a half bridge and eventually wind a high voltage transformer I can drive with this. Was also curious if the UCC's would struggle with just the one brick up to around 200khz. Seems like they can do it.

This test transformer only had maybe 100 turns on the secondary but it was hissing pretty bad at only about 150V pk to pk on the primary. It could probably draw some pretty good arcs before crapping out if it was in oil. Ideally I would have about double the primary turns and run it at about 250-300V pk to pk.
Half Bridge Flyback/TC Driver 20-200khzSingle Ended QCWSSTC TestBig Rock 3S FPV DJI O3 4K TestBig Rock 3s FPV Squatch ReturnsQCWDRSSTC Miniblocs 420khz First Test16.5Mhz Plasma Donut CircuitMaking an Isolated DC to DC Converter Part 2DJI O4 Pro Low Light Driving (G3s)RC FPV 5.8ghz RunCam Thumb 1080p 60fps (H16BM w/Huge Tires)RC FPV DJI O4 Pro w/HEQ G-Port Gimbal Final Test (Fireteam 6s)SiC Half Bridge Drive Testing Crapola (UCC21530 + SN74LV4046)Big Rock 3s FPV Snooping
Magneticitist |

Half Bridge Flyback/TC Driver 20-200khz

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER