Uploaded January 2026 | Updated November 2026, 3 hours ago
Part 3 youtube.com/watch?v=9vh4M-4OwW0
This next session of screwing around was not only the most enlightening, but showed me how much time I wasted chasing something that just wasn't going to happen. Obviously, the transformer AKA the most difficult part to rework was the main problem. I probably said pullup instead of pulldown or vice versa more than once so just ignore that and look at the drawing instead lol.
I would say I kind of automatically sized parts I had for more power than I really needed so maybe the next one of these I make will largely focus on the size of the transformer relative to how high of an oscillator frequency I can comfortably bring the switching. Maybe some tiny toroid won't be so difficult to wind with roughly the same turns or fewer at 3x the frequency. Some 75-100V SMD switches and boom it seems easy enough to get it down to the size of a 5-10W continuous unit that can push 15V-24V for gate drives at maybe 1/4 the size or less.
If I can get those peaks clamped down to around the 55-60V region from my 24V input then I'll probably just go ahead and throw this thing in my QCW logic supply and try to make another smaller one. It should be fine since I'd leave the output at 24V where there are no peaks above 2x Vin.
Part 3 youtube.com/watch?v=9vh4M-4OwW0
This next session of screwing around was not only the most enlightening, but showed me how much time I wasted chasing something that just wasn't going to happen. Obviously, the transformer AKA the most difficult part to rework was the main problem. I probably said pullup instead of pulldown or vice versa more than once so just ignore that and look at the drawing instead lol.
I would say I kind of automatically sized parts I had for more power than I really needed so maybe the next one of these I make will largely focus on the size of the transformer relative to how high of an oscillator frequency I can comfortably bring the switching. Maybe some tiny toroid won't be so difficult to wind with roughly the same turns or fewer at 3x the frequency. Some 75-100V SMD switches and boom it seems easy enough to get it down to the size of a 5-10W continuous unit that can push 15V-24V for gate drives at maybe 1/4 the size or less.
If I can get those peaks clamped down to around the 55-60V region from my 24V input then I'll probably just go ahead and throw this thing in my QCW logic supply and try to make another smaller one. It should be fine since I'd leave the output at 24V where there are no peaks above 2x Vin.










