Uploaded March 2026 | Updated November 2026, 3 hours ago
Not a dedicated build or anything but just yet another example of a QCWSSTC but this time I'm using a single IGBT layout. Running around the 400khz region is where the enable gating comes in handy as even with just the single switch, a bipolar drive that high is still fairly demanding on the drivers at 15V. Maybe 700khz or something is doable, and higher with a mosfet. Kind of fun just throwing random builds on the output of the buck where with something like this, the only real lingering question I have is how small of a DC reservoir I can get away with.
As poorly tuned as it is, it's still acceptable for some small SSTC single ended build. I would imagine that with a topology like this, at around the 100VDC input range where let's say the pk ramp voltage is a little under that at low on times, the drain/collector is probably swinging to 200V or more easily.
It could be plenty more than that without a snubber. So even with the 650V switch I would only run like 200V max peaks. For what it seems I can get at 100V input, 200V seems enough headroom to hit 1.5ft arcs or longer.
The ramp on times I was running in this video were just over a full 60hz half cycle max.. so more or less the equivalent of staccato interrupting at approx ~60VAC input with ~8ms ramps. Imagining I had it tuned to properly run 120VAC, I'd otherwise just be mainly worried that I'm not over-volting the collector. Pk power in a setup like this should be fairly close to the RMS capability of the switch I'm using, so I'd imagine a smallish mosfet could easily do it as well. It may still be better to just use two small fets in a half bridge so some kind of ballpark series primary cap can be used to lengthen the arcs.
Not a dedicated build or anything but just yet another example of a QCWSSTC but this time I'm using a single IGBT layout. Running around the 400khz region is where the enable gating comes in handy as even with just the single switch, a bipolar drive that high is still fairly demanding on the drivers at 15V. Maybe 700khz or something is doable, and higher with a mosfet. Kind of fun just throwing random builds on the output of the buck where with something like this, the only real lingering question I have is how small of a DC reservoir I can get away with.
As poorly tuned as it is, it's still acceptable for some small SSTC single ended build. I would imagine that with a topology like this, at around the 100VDC input range where let's say the pk ramp voltage is a little under that at low on times, the drain/collector is probably swinging to 200V or more easily.
It could be plenty more than that without a snubber. So even with the 650V switch I would only run like 200V max peaks. For what it seems I can get at 100V input, 200V seems enough headroom to hit 1.5ft arcs or longer.
The ramp on times I was running in this video were just over a full 60hz half cycle max.. so more or less the equivalent of staccato interrupting at approx ~60VAC input with ~8ms ramps. Imagining I had it tuned to properly run 120VAC, I'd otherwise just be mainly worried that I'm not over-volting the collector. Pk power in a setup like this should be fairly close to the RMS capability of the switch I'm using, so I'd imagine a smallish mosfet could easily do it as well. It may still be better to just use two small fets in a half bridge so some kind of ballpark series primary cap can be used to lengthen the arcs.










