Uploaded December 2023 | Updated November 2026, 3 hours ago
Here's a pretty basic design for anyone who wants to build one of these and utilize one of those glow bulbs Termadnator discovered produces the toroid.
Anyone can really just build most any of the available HFSSTC circuits already out there and it should work, but if you want to build one you can also see up close then it shouldn't be too hard to copy this layout. You don't need a board for it but it definitely makes it easier to keep things tidy and in the same spots. There's also no point to the large heatsink unless you want to run another resonator or other higher current drawing loads for long periods
For a reference circuit I can't think of much other than one of Teslaundmehr's old circuits on this forum highvoltageforum.net/index.php?topic=298.0
AcidByte also has some circuits you can check out
This one is using:
IRFP260M
2.75 turn 12AWG copper inductor, 3 inch diameter with 1cm turn spacing
5KV 100pF Ceramic RF capacitor
2.5nF Gate capacitance (This is just what I had at the time)
2x 1K resistors
10K potentiometer
3x 13V Zeners (Again, just what I had and probably not necessary to add the other two)
18 turn 2.5cm diameter RF choke (about 7uH)
and wabam you're slam dunkin donuts
Here's a pretty basic design for anyone who wants to build one of these and utilize one of those glow bulbs Termadnator discovered produces the toroid.
Anyone can really just build most any of the available HFSSTC circuits already out there and it should work, but if you want to build one you can also see up close then it shouldn't be too hard to copy this layout. You don't need a board for it but it definitely makes it easier to keep things tidy and in the same spots. There's also no point to the large heatsink unless you want to run another resonator or other higher current drawing loads for long periods
For a reference circuit I can't think of much other than one of Teslaundmehr's old circuits on this forum highvoltageforum.net/index.php?topic=298.0
AcidByte also has some circuits you can check out
This one is using:
IRFP260M
2.75 turn 12AWG copper inductor, 3 inch diameter with 1cm turn spacing
5KV 100pF Ceramic RF capacitor
2.5nF Gate capacitance (This is just what I had at the time)
2x 1K resistors
10K potentiometer
3x 13V Zeners (Again, just what I had and probably not necessary to add the other two)
18 turn 2.5cm diameter RF choke (about 7uH)
and wabam you're slam dunkin donuts










