Uploaded December 2023 | Updated November 2026, 3 hours ago
This is going to be my first test circuit for when I get the bulbs and then I'll build another one on a cleaner setup with an inductor winding that's more designed around the exact shape of the bulb. Just showing the operation of this circuit at higher voltages, though it still emits a small flame at down to around 15v or so from a rounded screw head. Mosfet is another IRFP260M, 100pF resonant cap, about 6nF gate drive, and secondary resonator I tried to wind and tune so I could run it both coupled and uncoupled. I also know that unloaded the LC can also output a good amount of power at the same frequency. The question is how well will a visible toroid develop by just tossing it on a known 'decently working' circuit.
Just trying to blast power is not necessarily a good approach though I'm thinking, because if the LC is not loaded enough it's just going to heat up a lot. The diameter of this coil is probably a little too large for the glow bulbs but I'm thinking I can get away with just tightening the top turn. If anyone knows anything more on sources for good globes please let me know
This is going to be my first test circuit for when I get the bulbs and then I'll build another one on a cleaner setup with an inductor winding that's more designed around the exact shape of the bulb. Just showing the operation of this circuit at higher voltages, though it still emits a small flame at down to around 15v or so from a rounded screw head. Mosfet is another IRFP260M, 100pF resonant cap, about 6nF gate drive, and secondary resonator I tried to wind and tune so I could run it both coupled and uncoupled. I also know that unloaded the LC can also output a good amount of power at the same frequency. The question is how well will a visible toroid develop by just tossing it on a known 'decently working' circuit.
Just trying to blast power is not necessarily a good approach though I'm thinking, because if the LC is not loaded enough it's just going to heat up a lot. The diameter of this coil is probably a little too large for the glow bulbs but I'm thinking I can get away with just tightening the top turn. If anyone knows anything more on sources for good globes please let me know










