RC FPV Fireteam 4s DJI O4 Pro Reception Test (Goggles 3) @Magneticitist
RC FPV Fireteam 4s DJI O4 Pro Reception Test (Goggles 3)  @Magneticitist
Uploaded February 2025 | Updated November 2026, 2 days ago
Ran this thing a few times now and this is the first legit cruise on clear roads so far. I'm still showing the Goggles view to convey how the image looks in various locations. I'm back to a Crossfire Diversity receiver now with an upgraded antenna so I should have real solid control range and an extra channel to use. I wanted to make sure it was working right and also wanted to push the signal limits more in this familiar area. Bringing it down to 0Mbps was not something I expected but I suppose the O3 equivalent would have shown 0.5Mbps or something. I'm not so sure it would have held on without blacking out though. While functionally there isn't much difference between a total blackout and a stuck screen, the total blackout stops the video recording. Since I still had good audio maybe I should consider adding the analog camera as a backup again. Even if it looks bad it still might be good enough to navigate back to better signal when I'm not in an open field with less chance for mistakes. I can just make it controller switched so it's not wasting power when not in use, and it can play on a small screen I just plug into the receiver I already have with me.

It seemed like the controls are working real good since I didn't hear any audio degradation when the signal on the O4 dropped to below 1Mbps. This means the Crossfire didn't have to dynamically ramp to some high power level like 250mW+, which would start to interfere with the 1280mhz audio receiver even with a notch filter on it.

This truck handles really well on road or off road but it's not real fast on 4s with the stock 12T pinion. The speed pinion that comes with it doesn't really bump it up that much either. For decent speed I would probably run this on 6s with the stock pinion to get close to 50mph tops but for now I'll just get used to a max of about ~35mph. Even with a roll cage I doubt the thing will handle 6s top speed crashes without breaking something.

Hopefully I'll get my LCD screen before too long and can test that out. The rear view mirror kind of works but I don't have enough height on it to get a good perspective. To get the steering wheel moving I just added a micro servo behind it with a semi rigid flexible antenna holder for the linkage. That way it can sit at a little bit of an angle and nothing can get overtorqued. The servo is just mixed into the steering channel but I guess I could also split it to save a channel. The dudes arm is already kind of movable but I just trimmed the joint cutout a little wider and loosened the holding screw a little bit.
RC FPV Fireteam 4s DJI O4 Pro Reception Test (Goggles 3)Typhon 3s RC FPV Awesome Park Roam (DJI O3 + Crossfire)HFSSTC Class E 11Mhz 350WARRMA Typhon 3s FPV  w/Traxxas Slash 3s Toy TimePLL Full Bridge Induction Heater Feedback TestBig Rock 3s FPV ExploringDJI O4 Pro w/HEQ Gimbal on Typhon 3s w/Live Rear CamRC FPV From Living Room ARRMA Big RockAnother Plasma Donut CircuitH-Bridge Induction Heater & DRSSTC Driver OCP TestTyphon 3s FPV Wandering AroundQCW SSTC Double Full Bridge First Test
Magneticitist |

RC FPV Fireteam 4s DJI O4 Pro Reception Test (Goggles 3)

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER