M435 Unboxing & Assembly @Radiolink_official
M435 Unboxing & Assembly  @Radiolink_official
Uploaded May 2024 | Updated November 2026, 5 days ago
M435 comes with RadioLink AT9S Pro transmitter. You can also choose other transmitters to control it.
lanyard, power cable,

Here are the accessories including support rods, landing gear, fixed columns for the landing gear, and so on.
M435, the load plate with a digital servo on it.

Then we’ll show the assembly of M435.
We need the load plate, and the accessory pack.
The end with the camera is the nose of the aircraft.

At first, overturn the aircraft.
Take out all the accessories. The fixed columns, landing gear, support rods, and screws.
The supports rods are placed on both sides of the fuselage to make the frame stronger.

The side of the support rod with the metal cap faces outward.
So place the support rod like this. Place it into the slot. The same way for the other side.
Don’t tighten the screws now.

Take out the landing gear and fixed columns.
There are 2 packs of screws. We use the long screws to install the landing gear.

Overturn the aircraft and insert the screws from the back.
Then we can use the Screwdriver Socket Wrench which comes with M435 to tighten the screw. To save the time, I use electronic screwdriver. Tighten the two supports rods with the same method.
This is what it looks like after the support rods are well installed.

Next, install the fix columns. There are 4 corners in total, with 2 columns in each corner. Rotate the 8 columns to fix them. Done.

Here is the landing gear. The foam side faces the ground.
Use the short screws. Tighten them.
This is what it looks like after the landing gear is assembled.

Then install the load plate. It comes with 8 short screws.
overturn the aircraft. Here is the hook to hook the loads. So it is recommended to install the hook at the center of the gravity of the aircraft. Like this.
The empty space on the load plate is to place the camera. Like this.
The digital servo can be connected to the cable here. Connect them based on the colors of the wires.
Wrap the cables under the plate and tighten the 8 screws.

This is how the hook works.
In the next episode, we’ll introduce how to install the throwing plate and camera tilt servo.

For more details of M435:
radiolink.com/m435

If any question about M435, please feel free to contact us via email: after_service@radiolink.com.cn

#drone #heavy lift drone #radiolink
M435 Unboxing & AssemblyProfessional designer and manufacturer of RTF plane kits and accessories for about 23 years!RadioLink RC8X Controls JDM-98 Hydraulic BulldozerDual Rate and End Point Function of T8S/T8FB TransmitterHow to Update the Firmware of RC8P?Binding and Working Modes of R16SMHow to Make Customized Switch Voice on RC8P?Programmable Mixing Function of RC8XHome Screen Introduction of RadioLink T16D/T12D TransmitterBinding & Working Modes of R16FEasy to change the Radiolink RC8X Home Screen Wallpaper!!!Radiolink F108 | Optical Flow PosHold FPV Racing Drone
RadioLink |

M435 Unboxing & Assembly

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER