Plan C | Reprap Atom X 3d Printed 3d Printer - FInally Finalized! @Plan-C | Uploaded November 2017 | Updated October 2024, 1 hour ago.
Quick video showing some test prints on my 3D printed 3D Printer Benchy and X/Y accuracy). Both are fine and the unit is pretty much 'set and forget' now.
I have modified the Atom X to have a 120*120mm heated bed, BLTouch autoleveller and have upgraded the endstops and coolers/ducts. I have extended the Y carriage and sled to accommodate the BLTouch and allow it to use the full plate.
I run it with Marlin now (much better) and attach the latest config.
The mods I made are on Thingiverse and can be found here:
google.co.uk/url?sa=t&source=web&rct=j&url=thingiverse.com/thing:2531222&ved=0ahUKEwjc_ILaqZ7XAhWCExoKHX3ZBnkQFggqMAE&usg=AOvVaw07v_uhXjVk8p2FikHB3nC6
My latest Marlin config is here:
drive.google.com/folderview?id=0BzujMMpM5EE4NUNkU3F3RW9XSk0
The original AtomX can be found here:
reprap.org/wiki/AtomX
Good luck all.
Quick video showing some test prints on my 3D printed 3D Printer Benchy and X/Y accuracy). Both are fine and the unit is pretty much 'set and forget' now.
I have modified the Atom X to have a 120*120mm heated bed, BLTouch autoleveller and have upgraded the endstops and coolers/ducts. I have extended the Y carriage and sled to accommodate the BLTouch and allow it to use the full plate.
I run it with Marlin now (much better) and attach the latest config.
The mods I made are on Thingiverse and can be found here:
google.co.uk/url?sa=t&source=web&rct=j&url=thingiverse.com/thing:2531222&ved=0ahUKEwjc_ILaqZ7XAhWCExoKHX3ZBnkQFggqMAE&usg=AOvVaw07v_uhXjVk8p2FikHB3nC6
My latest Marlin config is here:
drive.google.com/folderview?id=0BzujMMpM5EE4NUNkU3F3RW9XSk0
The original AtomX can be found here:
reprap.org/wiki/AtomX
Good luck all.