Uploaded October 2026 | Updated November 2026, 4 days ago
Toshiba SA-725, 25WPC, 1978 STK Amp
Here’s a little receiver that was acquired from the same place as my Sansui G-9000 around 2019.
And it’s had it share of small issues but tonight it’s singing well.
Thomas Brander helped me identify a bad zener diode replacement about six years ago via a Facebook chat. This is a receiver I bring out from time to time from my collection and upon power up a week ago, I noticed that the bass potentiometer had no effect on the right channel. I also noticed that the combination power/speaker selector switch knob was not working right and the display and system power was flickering.
So I tore it apart, discovered a bad bass pot and I happen to have a longer stem replacement on hand (without the indent spacing bumps unfortunately, which I truly love).
I then disassembled the Alps power switch, sanded down the contacts, and bent the contacts to be in a better position. It’s now passing the 120v voltage exactly as it should. Tech note: leave the power switch in the “on” position when not being used or stored. This will take the strain off of the metal contacts during inactivity.
Finally, I recapped the tone, power, and amplifier circuit. I left the two larger caps intact - while I didn’t test them, I’ve never really seen those ever go bad in ANY receiver of this vintage.
This receiver sounds much louder than 25 watts. It’s powering my Pioneer HPM-100 speakers just fine tonight.
A final note, this does have an STK chip in the amp. I cleaned up and added new thermal paste and re-tightened, apparently some of the older STK‘s are more reliable, but I don’t know that for a fact.
My troubleshooting and repair skills have come along way, thanks to the Facebook community.
Toshiba SA-725, 25WPC, 1978 STK Amp
Here’s a little receiver that was acquired from the same place as my Sansui G-9000 around 2019.
And it’s had it share of small issues but tonight it’s singing well.
Thomas Brander helped me identify a bad zener diode replacement about six years ago via a Facebook chat. This is a receiver I bring out from time to time from my collection and upon power up a week ago, I noticed that the bass potentiometer had no effect on the right channel. I also noticed that the combination power/speaker selector switch knob was not working right and the display and system power was flickering.
So I tore it apart, discovered a bad bass pot and I happen to have a longer stem replacement on hand (without the indent spacing bumps unfortunately, which I truly love).
I then disassembled the Alps power switch, sanded down the contacts, and bent the contacts to be in a better position. It’s now passing the 120v voltage exactly as it should. Tech note: leave the power switch in the “on” position when not being used or stored. This will take the strain off of the metal contacts during inactivity.
Finally, I recapped the tone, power, and amplifier circuit. I left the two larger caps intact - while I didn’t test them, I’ve never really seen those ever go bad in ANY receiver of this vintage.
This receiver sounds much louder than 25 watts. It’s powering my Pioneer HPM-100 speakers just fine tonight.
A final note, this does have an STK chip in the amp. I cleaned up and added new thermal paste and re-tightened, apparently some of the older STK‘s are more reliable, but I don’t know that for a fact.
My troubleshooting and repair skills have come along way, thanks to the Facebook community.










