Uploaded June 2024 | Updated November 2026, 3 hours ago
This is the build using a full bridge of miniblocs and a drsstc driver with PLL feedback. Combined with a buck on the front and 10,000uF of caps + Finn Hammer's arduino ramp generator it's a dual resonant QCW with crappy tuning so far.
I been on this thing for a while kind of hoping I'd land on a specific tuning that got me a big enough improvement to be happy about. That sort of happened with my first one, but then going back and playing with it I just wasn't too impressed with it. The ramps weren't as clean as what I'd recently been used to and there was a sound in the arcs I didn't like. I don't have any of those problems with this build but the arcs aren't even as long at higher voltage.
At first I would notice longer arcs at lower voltages, combined with no appreciable increase at higher voltages. So then I thought I had an idea about the tuning to where I'd be looking at shorter arcs at the same lower voltages, but they would increase in length appreciably at the higher voltages. I never actually saw that outcome to any acceptable degree.
I'll probably take it through one last stage of tuning where I try to see how it runs at 300VDC ramps. Right now it's basically just a random primary length and cap bank tap I stuck with cause none of it really made much difference anyway. I think I'm at like 15nF right now.
Could be the resonant caps but IDK without replacing them. Adding the bigger topload and tuning it didn't make any positive difference. Neither did trying lower or higher primary impedance. No matter how I changed it I could always find the tuning region again and tweak it, but never end up with anything better than I had at first. If I can't improve it I'll have to scrap it and rebuild since it's too heavy right now anyway.
This is the build using a full bridge of miniblocs and a drsstc driver with PLL feedback. Combined with a buck on the front and 10,000uF of caps + Finn Hammer's arduino ramp generator it's a dual resonant QCW with crappy tuning so far.
I been on this thing for a while kind of hoping I'd land on a specific tuning that got me a big enough improvement to be happy about. That sort of happened with my first one, but then going back and playing with it I just wasn't too impressed with it. The ramps weren't as clean as what I'd recently been used to and there was a sound in the arcs I didn't like. I don't have any of those problems with this build but the arcs aren't even as long at higher voltage.
At first I would notice longer arcs at lower voltages, combined with no appreciable increase at higher voltages. So then I thought I had an idea about the tuning to where I'd be looking at shorter arcs at the same lower voltages, but they would increase in length appreciably at the higher voltages. I never actually saw that outcome to any acceptable degree.
I'll probably take it through one last stage of tuning where I try to see how it runs at 300VDC ramps. Right now it's basically just a random primary length and cap bank tap I stuck with cause none of it really made much difference anyway. I think I'm at like 15nF right now.
Could be the resonant caps but IDK without replacing them. Adding the bigger topload and tuning it didn't make any positive difference. Neither did trying lower or higher primary impedance. No matter how I changed it I could always find the tuning region again and tweak it, but never end up with anything better than I had at first. If I can't improve it I'll have to scrap it and rebuild since it's too heavy right now anyway.










