Uploaded January 2015 | Updated September 2026, 2 weeks ago
Printing all the gen one starter pokèmon on my Ultimaker 2.
Filament :Ultimate Blue by Ultimaker
Leaf Green by colorFabb
Warm Red by colorFabb
Signal Yellow by colorFabb
Models : by FLOWALISTIK
Thingiverse : thingiverse.com/FLOWALISTIK/about
Music : Pokemon Gym Leader Battle! by Audio Sprite
Pokémon - Red Blue Opening Theme by RAC
Pikachu specifically:
Printed at 2x scale, layer height 0.1 mm, 50 mm/s.
20% infill.
225c on nozzle,
60c on the bed,
fan at 100% from 1mm up.
As always used hairspray for bed adhesion!
This was my first attempt at changing filament mid-print,
i just waited til the first roll was done and jammed the next one
right behind up the feeder! It worked great, but i had to disable retraction of course since the "old" filament was just pushed and had no mechanical link to the feeder. Hence the awful stringing between the ears of Pikachu. But it was easy to clean off with a knife.
Came out great! I love these models!
Check out my print of Squirtle and
youtube.com/watch?v=VS-z5e72gmA
Bulbasaur!
youtube.com/watch?v=kmUa7LvD3lM
And Charmander!
youtube.com/watch?v=R013Z_43iuo
Follow me on twitter @Multimaker3d
And follow @Flowalistik for his great models!
Printing all the gen one starter pokèmon on my Ultimaker 2.
Filament :Ultimate Blue by Ultimaker
Leaf Green by colorFabb
Warm Red by colorFabb
Signal Yellow by colorFabb
Models : by FLOWALISTIK
Thingiverse : thingiverse.com/FLOWALISTIK/about
Music : Pokemon Gym Leader Battle! by Audio Sprite
Pokémon - Red Blue Opening Theme by RAC
Pikachu specifically:
Printed at 2x scale, layer height 0.1 mm, 50 mm/s.
20% infill.
225c on nozzle,
60c on the bed,
fan at 100% from 1mm up.
As always used hairspray for bed adhesion!
This was my first attempt at changing filament mid-print,
i just waited til the first roll was done and jammed the next one
right behind up the feeder! It worked great, but i had to disable retraction of course since the "old" filament was just pushed and had no mechanical link to the feeder. Hence the awful stringing between the ears of Pikachu. But it was easy to clean off with a knife.
Came out great! I love these models!
Check out my print of Squirtle and
youtube.com/watch?v=VS-z5e72gmA
Bulbasaur!
youtube.com/watch?v=kmUa7LvD3lM
And Charmander!
youtube.com/watch?v=R013Z_43iuo
Follow me on twitter @Multimaker3d
And follow @Flowalistik for his great models!
