Uploaded September 2026 | Updated November 2026, 3 hours ago
You don’t necessarily need a special router bit to chamfer acrylic. Here I’m using a standard 45° chamfer bit that would normally be used for woodworking. The biggest adjustment is router speed. Running too fast creates heat, which can start melting the acrylic instead of cutting it cleanly.
I dropped the router down to about 13,000 RPM, kept the material moving, and it left a really clean edge. If you need to chamfer or profile acrylic, you may already have the bit you need. Check out the tools used on our site -
Amana Tool 45° chamfer bit, item no. 49400 - toolstoday.com/v-5830-49400.html
SawStop In-Line Router Table, item no. RT-TGI - toolstoday.com/sawstop-rt-tgi-30-in-line-cast-iron-router-table-for-ics.html
You don’t necessarily need a special router bit to chamfer acrylic. Here I’m using a standard 45° chamfer bit that would normally be used for woodworking. The biggest adjustment is router speed. Running too fast creates heat, which can start melting the acrylic instead of cutting it cleanly.
I dropped the router down to about 13,000 RPM, kept the material moving, and it left a really clean edge. If you need to chamfer or profile acrylic, you may already have the bit you need. Check out the tools used on our site -
Amana Tool 45° chamfer bit, item no. 49400 - toolstoday.com/v-5830-49400.html
SawStop In-Line Router Table, item no. RT-TGI - toolstoday.com/sawstop-rt-tgi-30-in-line-cast-iron-router-table-for-ics.html










