Uploaded August 2023 | Updated September 2026, 2 weeks ago
Printed this with 0.1 Layer height tuning Goliath hot end.
Crossed gantry printer, no name brand.
Goliath hotend, air cooled with Berd Air assisted cooling
VZHextrudort extruder
VaLvNaToR cooling duct
48V gantry and extruder motor
LDO 2504AC gantry motors
I have been whooped on dry filament so many time.. DRY YOUR FILAMENT!
I would also like to add.. there is a mod for fan speed scaling that is perfect for me! If your fan only starts to run at 20% you can change the fan.py file, change your printer.cfg, then 1% commanded will be 20% and scaled to 100%. This is really good!! Considering typically your slicer will scale from 0-20 with no fan output if your fan only starts to work at 20%. Can't wait for this to be merged to klipper!
github.com/Klipper3d/klipper/pull/6307
Printed this with 0.1 Layer height tuning Goliath hot end.
Crossed gantry printer, no name brand.
Goliath hotend, air cooled with Berd Air assisted cooling
VZHextrudort extruder
VaLvNaToR cooling duct
48V gantry and extruder motor
LDO 2504AC gantry motors
I have been whooped on dry filament so many time.. DRY YOUR FILAMENT!
I would also like to add.. there is a mod for fan speed scaling that is perfect for me! If your fan only starts to run at 20% you can change the fan.py file, change your printer.cfg, then 1% commanded will be 20% and scaled to 100%. This is really good!! Considering typically your slicer will scale from 0-20 with no fan output if your fan only starts to work at 20%. Can't wait for this to be merged to klipper!
github.com/Klipper3d/klipper/pull/6307
