Uploaded November 2025 | Updated September 2026, 2 weeks ago
This is a 5 minute vase mode rose. Flow was ~57 for the entire print. I used an old file and printed it as it to see if I can get a comparison/1st impression.
This is ABS, 280C, .4 nozzle, .6 line width.
My initial impression is they need some work in the tuning dept. Not only for servos, but also for my slice. I see some machine issues as well as servo. But we can get some baseline prints and move forward.
This is a 5 minute vase mode rose. Flow was ~57 for the entire print. I used an old file and printed it as it to see if I can get a comparison/1st impression.
This is ABS, 280C, .4 nozzle, .6 line width.
My initial impression is they need some work in the tuning dept. Not only for servos, but also for my slice. I see some machine issues as well as servo. But we can get some baseline prints and move forward.
