Threaded with 10-32 tap for PlasmaCNC Gantry @UDoIt2
Threaded with 10-32 tap for PlasmaCNC Gantry @UDoIt2
Uploaded April 2025 | Updated September 2026, 3 weeks ago
Working on the PlasmaCNC gantry. This piece is 2 1/2 inch square tubing that will slide over the PlasmaCNC's 2 inch square tubing axis. 3D Printed bearing blocks will be used to separate the outside tube from the axis tube.

Video Credits:
Video Production: U Do It™️ Studios a Division of No Cheese Records LLC All Rights Reserved. No Cheese Records® is a Registered Trademark of No Cheese Records LLC All Rights Reserved.
Threaded with 10-32 tap for PlasmaCNC GantryUsing Hillman Picture Hanging Kit to hang beachy picturesMy guild banned me - Logitech MX Master 3 Buttons failed during a raidUDoIt How to Fix a Cracked Garage DoorAnchorlube came highly recommended by others who use itU Do It - No Cheese Anthem (Feat. Savvy Turtle, Northside Nate) (Official Visualization Video)Scotts Triple Action really controls the weedsDrilling clear throught opposite side of seam didnt work as I expected #failbigIs it any easier to drill through a pilot hole with a large bit?My mild steel fabrication skills are evolvingU Do It Reviews Lighting - How to Install a Gooseneck Barn LampRestore your headlights in your driveway
U Do It |

Threaded with 10-32 tap for PlasmaCNC Gantry

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER