Uploaded September 2024 | Updated November 2026, 2 days ago
Very cheap and easy fix to rectify stick drift on a controller or gamepad using only a couple of resistors. Worked when replacing the gimbals did not. Compensates for tuning at factory for original sticks.
Cheaper than new gimbal. Minimal disassembly, fairly basic tools (soldering iron, solder, a few resistors)
Worth a shot if all else fails. Should also work on drone controllers etc. will not work for Hall Effect (magnetic) based sticks.
Video covers basic idea, testing different values and gives some rough suggested started test values. The calculation for resistors in parallel is complicated but they are just my findings through experimenting.
WARNING! I SAY THE WORD 'POT' A LOT IN THIS VIDEO LOL
Good Luck All
Very cheap and easy fix to rectify stick drift on a controller or gamepad using only a couple of resistors. Worked when replacing the gimbals did not. Compensates for tuning at factory for original sticks.
Cheaper than new gimbal. Minimal disassembly, fairly basic tools (soldering iron, solder, a few resistors)
Worth a shot if all else fails. Should also work on drone controllers etc. will not work for Hall Effect (magnetic) based sticks.
Video covers basic idea, testing different values and gives some rough suggested started test values. The calculation for resistors in parallel is complicated but they are just my findings through experimenting.
WARNING! I SAY THE WORD 'POT' A LOT IN THIS VIDEO LOL
Good Luck All










