Adding a Homemade Saver to a PSU / Inside a Commodore 64 @Plan-C
Adding a Homemade Saver to a PSU / Inside a Commodore 64  @Plan-C
Uploaded October 2017 | Updated November 2026, 35 minutes ago
First part of the video shows modification of an original (Micro Mate) C64 power supply to include a homemade 5v failsafe device and external 5v Ok led. Also shows the idea behind the saver and some testing. I then swap out the original 5v regulator for a BEC for good measure.

Second part from 8:35 shows how to fit a smaller version of the saver inside a C64 so that it is protected from failure on the 5v rail on any supply.

The saver is not my idea and I have already ordered several savers and power supplies from Ray Carlsen. I just wanted to see if I could make one myself. I was happy with the result. It realiably cuts off at circa 5.4v, protecting the computer. The parts are very cheap and can be found here:

console5.com/wiki/Commodore_64_Power_Saver

Details of the saver, as well as a wealth of information about repairing Commodore computers can be found at Ray's website here:

personalpages.tds.net/~rcarlsen
Adding a Homemade Saver to a PSU / Inside a Commodore 64How to Spot Fake, Dangerous Power Leads  and Teardown of dodgy Gearbest T8 CNC Power SupplyNetgear Power Supply Repair (& Moan About Some eBay Chargers)Amiga 500 Plus black screen fixed (Older Vid - Rough Audio)Octopi and Smartplug Over-temp Shutoff Protection for 3D PrinterAmiga 500 (Heavy) PSU Brief Walkthrough & RepairFix Pixel 7 / 7 Pro (& Probably Other Pixels) No Mic After Screen Replacement. Cause Identified.Fatshark 18650 Battery Case Reverse Polarity Protection ModArchimedes A3000 Finally Solved!How to get FX8350 to 4.6ghz per Core on AirHow to limit yaw servo travel on APM 2.5 TricopterHow to waterproof a KK2 board
Plan C |

Adding a Homemade Saver to a PSU / Inside a Commodore 64

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER