Uploaded June 2024 | Updated September 2026, 1 week ago
Well, first three things....
#1; This IS NOT part of the DT-02 speed challenge Peter Smith of CW-01 Creations is hosting....
#2; My camera angle really sucked as I was doing passes in front of the camera, but I ain't doing it over..... I'll get better footage of a run AFTER I put the ball bearings in the buggy.
#3; as I edited this, 6/27/2024 (27/6/2024 for weird way), I noticed I have on the TAMIYA TT-02B/DF-03 Aluminum Damper Set #54993, I test fitted them and forgot to take them off....
This is almost a stock buggy, it has a Tamiya Super stock BZ 23 turn motor (#53930), 17 tooth pinion, and of course, as I stated above, those dampers.
I was running on/with a Gartpot 4000mAh 50c 2S lipo pack.
Both motors have locked timing, both motors have bushings (bushes, again the weird way).. However, the Tamiya is a 23 turn motor & the Trinity is a 27 turn motor. Maybe a dyno test of the two is in order.....
If you missed the run with the Trinity Paradox Pro motor, this is the link
youtu.be/tJPx-kxwhzk?si=aihx13w4iyHPjjYj
@theoagrc
Hey Craig, it sounds typical in this run, but not as loud as yours mate, please look at your gears and/or diff.. I don't wanna see you burn anything up cause things are getting hot.. Hell, use a temp gun on the motor after a few passes and check the temp, then compare that to a buggy that's much more quiet.
Thanks RC Elf for the kit
Thank You all for Watching...
Please leave a comment if you wish...
Criticism is also welcome...
Well, first three things....
#1; This IS NOT part of the DT-02 speed challenge Peter Smith of CW-01 Creations is hosting....
#2; My camera angle really sucked as I was doing passes in front of the camera, but I ain't doing it over..... I'll get better footage of a run AFTER I put the ball bearings in the buggy.
#3; as I edited this, 6/27/2024 (27/6/2024 for weird way), I noticed I have on the TAMIYA TT-02B/DF-03 Aluminum Damper Set #54993, I test fitted them and forgot to take them off....
This is almost a stock buggy, it has a Tamiya Super stock BZ 23 turn motor (#53930), 17 tooth pinion, and of course, as I stated above, those dampers.
I was running on/with a Gartpot 4000mAh 50c 2S lipo pack.
Both motors have locked timing, both motors have bushings (bushes, again the weird way).. However, the Tamiya is a 23 turn motor & the Trinity is a 27 turn motor. Maybe a dyno test of the two is in order.....
If you missed the run with the Trinity Paradox Pro motor, this is the link
youtu.be/tJPx-kxwhzk?si=aihx13w4iyHPjjYj
@theoagrc
Hey Craig, it sounds typical in this run, but not as loud as yours mate, please look at your gears and/or diff.. I don't wanna see you burn anything up cause things are getting hot.. Hell, use a temp gun on the motor after a few passes and check the temp, then compare that to a buggy that's much more quiet.
Thanks RC Elf for the kit
Thank You all for Watching...
Please leave a comment if you wish...
Criticism is also welcome...
