Uploaded July 2010 | Updated November 2026, 3 hours ago
Senko Hanabi made with Pine charcoal.
60 Potassium Nitrate
24 Sulfur
16 Charcoal (Pine, airfloat)
The pine charcoal was ball milled for many hours until very fine, then entire composition was ball milled until homogeneous. The paper is kitchen sandwich wrap paper (Tiger brand). The paper strip is cut about 15-20 mm wide and 200 mm long then folded into a "vee" along its length. A small amount of composition is placed near the end spread out over about 20-25 mm, then the paper is twisted up to retain the composition and form a handle for the device.
Whilst not the best performing device I have made this particular video displays the many phases of device operation. In particular the increase in temperature of the dross ball towards the end of the display causing a second phase of spark production operation where the paper is pyrolysed and consumed, fuelling the reaction sufficiently to disperse a large amount of the remaining dross as non-branching sparks. The test stand clip terminated the reaction early in this particular device by cooling the dross ball. Typically the second phase of non-branched sparks can continue for another 20 mm or more of paper until so much dross is lost that the surface area to volume ratio drops limiting oxygen availability and/or evaporative cooling causes the temperature of the dross ball to fall below a critical point.
Senko Hanabi made with Pine charcoal.
60 Potassium Nitrate
24 Sulfur
16 Charcoal (Pine, airfloat)
The pine charcoal was ball milled for many hours until very fine, then entire composition was ball milled until homogeneous. The paper is kitchen sandwich wrap paper (Tiger brand). The paper strip is cut about 15-20 mm wide and 200 mm long then folded into a "vee" along its length. A small amount of composition is placed near the end spread out over about 20-25 mm, then the paper is twisted up to retain the composition and form a handle for the device.
Whilst not the best performing device I have made this particular video displays the many phases of device operation. In particular the increase in temperature of the dross ball towards the end of the display causing a second phase of spark production operation where the paper is pyrolysed and consumed, fuelling the reaction sufficiently to disperse a large amount of the remaining dross as non-branching sparks. The test stand clip terminated the reaction early in this particular device by cooling the dross ball. Typically the second phase of non-branched sparks can continue for another 20 mm or more of paper until so much dross is lost that the surface area to volume ratio drops limiting oxygen availability and/or evaporative cooling causes the temperature of the dross ball to fall below a critical point.










