Uploaded March 2023 | Updated November 2026, 3 hours ago
Took a day off to try and get a bit better. Still feeling pretty bad, but improving slowly.
Light day of work today, started late after taking care of other chores. Ran out of light a bit short of half way insulating the floor deck. Probably another half-day to finish it up including expanding foam in any poorly sealing spots. Then comes probably the most annoying part of the entire build - placing and screwing down the subfloor plywood. Will definitely need some help with that, subfloor sheets are too heavy and awkward to easily place solo.
The hot-knife makes much less mess than the circular saw, but it is significantly slower. I'll try the shorter blade tomorrow, I don't need the 100 mm one. The shorter one should be a lower impedance and heat up quicker and cut faster - hopefully - a good bit of time is waiting for the knife to get up to temperature and the cut-rate is limited by the thermal load of the material as it cuts, so a better match between heated element and material is likely to improve cutting performance.
Took a day off to try and get a bit better. Still feeling pretty bad, but improving slowly.
Light day of work today, started late after taking care of other chores. Ran out of light a bit short of half way insulating the floor deck. Probably another half-day to finish it up including expanding foam in any poorly sealing spots. Then comes probably the most annoying part of the entire build - placing and screwing down the subfloor plywood. Will definitely need some help with that, subfloor sheets are too heavy and awkward to easily place solo.
The hot-knife makes much less mess than the circular saw, but it is significantly slower. I'll try the shorter blade tomorrow, I don't need the 100 mm one. The shorter one should be a lower impedance and heat up quicker and cut faster - hopefully - a good bit of time is waiting for the knife to get up to temperature and the cut-rate is limited by the thermal load of the material as it cuts, so a better match between heated element and material is likely to improve cutting performance.










