QCX Transceiver Part 3  - Phase Shift Network and Complete Audio Path @na5y
QCX Transceiver Part 3  - Phase Shift Network and Complete Audio Path  @na5y
Uploaded January 2020 | Updated November 2026, 1 day ago
In this video the Phase Shift network is installed. Then a simulated upper side band signal (I leading Q by 90 degrees) and lower side band signals are injected. The results are displayed on the oscilloscope

I decided to go ahead and install the 500 ohm IQ Balance pot which also completes the audio path and the simulated upper and lower sideband signals can be heard.

The book Experimental methods in RF design devotes a whole chapter to Phasing radios (Chapter 9). The phase shifter in the QCX is derived from the one in the Norcal NC2030

norcalqrp.org/nc2030.htm
QCX Transceiver Part 3  - Phase Shift Network and Complete Audio PathEnsemble RXTX Build #8 - Quadrature Sampling Encoder Phase ShiftIntroducing Georgia to the joy of magnesium ribbonSimple SDR with Arduino Audio ToolsESP32 Audio Processing with PCB Artists ES8388QST Wattmeter  - Part 6 Reflected Channel and dbm DisplayMC1496 Modulator and MixerQST Wattmeter -  Part 3 LF398 and first measurementNorcal Sierra - Part 7 Receive Mixer, Ladder Filter and Receiver On the AirQCX Amplifier TroubleshootingESP32 Based SDR Transmitter - Part 4 Transmitter on the AirESP32-A1S Radio on a Board - Part 1
NA5Y |

QCX Transceiver Part 3 - Phase Shift Network and Complete Audio Path

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER