Uploaded April 2017 | Updated November 2026, 3 days ago
1) Mn(II) added to conc. KCN solution, then air bubbled through
2) Mn(II) added to low concentration of KCN then air bubbled through.
Explanation will come soon !
1) Mn(II) added to conc. KCN solution, then air bubbled through
2) Mn(II) added to low concentration of KCN then air bubbled through.
Explanation will come soon !
, so the analogue to the yellow Ferrocyanide. We tried it with a huge excess of Cyanide and it would only turn green. So we had the idea to also add a bit of acid. The reason to why we did this is further explained in our RuCl3-solution video. As the acid was added it turned blue then colourless.
Literature says that a Cyanoruthenate(III) exists as well as slightly yellow compound. So we left a part of the solution open for two weeks and it turned slightly yellow in that time (end of the video). Strong acids are said to precipitate Ru(CN)3 from this.
About the blue compound that formed in between:
When we did this experiment the first time we used a solution of RuCl3 in a bit of HCl we had already prepared a few weeks earlier. The reason to this was that we expected it to become more reactive as in that time the tightly bound Chloride ligands might eventually exchange for more reactive aqua ligands. As it turns out whatever species may form in this time (this depends on the actual composition of the “RuCl3”) reacts completely different from a freshly prepared solution. When we did this experiment and heated it it turned blue. We might upload the video once we find out what actually happened. So we looked it up and found only one possible idea, mentioned in the literature a long time ago and never really tested again, a Ru2(CN)5H2O. This blue compound is said to form in hydrochloric acid and it seems to be blue. So we used some of the colourless solution and added it to a bit of acidified RuCl3 and after a day it was blue as well.
What we think happens is the following: Hexacyanoruthenate(II) and (III) undergo a quick ligand exchange which is accelerated by a reduced pH value to yield [Ru(CN)5(H2O)](3-). This might react with unreduced Ru(III) in solution (if the conc of Cyanide is too low or the RuCl3 is added later when the mixture is cold) and it could be analogous to Prussian Blue.
What we think happens in the reaction is the following. We also tried to add the acid first and then the Cyanide and it produced a lot of HCN before the Cyanide could even reach the bottom of the tube while the other way around didn’t produce much gases. So we believe that the Cyanide and RuCl3 in fact reacted at elevated temperatures but some Ru(IV)-species (for example) which is present in commercial RuCl3, or better just call it insoluble rests either wasn’t fully dissolved yet or not reactive enough. When the acid was added this unit broke apart the colourless Cyano complex formed. But this also induced the other reaction which forms the blue compound. This seems to build up as intermediate and is then reduced as the rest of Ru(III) in the complex is reduced to colourless Ru(II).
If you have any suggestion to what it is we would be happy for any answers. As mentioned before it’s hard to find anything on this topic. Many compounds have been postulated but never tested afterwards. Ruthenium Chemistry: Cyano-Ruthenate (II/III)](https://i.ytimg.com/vi/L7RRZ6esZlY/mqdefault.jpg)

If Silver meets Chloride insolbule Silver Chloride is formed. This can be dissolved again using Ammonia solution which formed the transparent [Ag(NH3)2](-) complex. Silver Chemistry: AgCl2 and [Ag(NH3)2](-)](https://i.ytimg.com/vi/LM6y9maUL68/mqdefault.jpg)





 complex forms but is substituted by chloride ligands once the mixture is heated. Then the blue [CoCl4](2-) forms. If the mixture is cooled down it turns pink again.
The reaction towards the chloro-ligand side is endothermic, therefore increasing the temperature will yield in a higher conc. of the blue product. Cobalt Chemistry: Cobalt Thermochromism (2016)](https://i.ytimg.com/vi/OVwtWZy_Lf4/mqdefault.jpg)
 and Oxidation to Chromate
In this video we will show another method to make Chromate(VI) from Chromium(III). Now this will only work if you manage to get Chromium(III) into solution. Some say that the Oxide which is readily available and therefore a cheap and easily accessible source for Chromate will dissolve in strongly alkaline conditions. We never really managed to dissolve it so for Chromium Oxide it might be better to use the other method we showed in a previous video.
Now as Potassium Hydroxide is added to some Chromium(III)Chloride the solution turns dark blue-purple with the formation of Cr(OH)3 or better [Cr(OH)3(H2O)3]. As more Hydroxide is added the three remaining water ligands are exchanged by OH(-) forming the soluble [Cr(OH)6](3-).
Some of this green solution is then transfered to a test tube and Hydrogen Peroxide is added. The mixture is heated and the Peroxide reacts with the Cr(III) forming Cr(VI). To test it we simply added some Sulfuric Acid. Since Hydrogen Peroxide is already present it just needs to be acidified to form the blue CrO5 and indicate the presence of Cr(VI).
Additional information:
Lets take a look at this deprotonation step above. Now we started using CrCl3 in water. This is already hard to describe as Cr(III) is really famous for its isomerism. We will have a video on that as well. It changes color between green/blue and purple quite for many Cr(III) compounds. Although pure [Cr(H2O)6]Cl3 is purple and our solution was dark green which is probably [CrCl2(H2O)4]Cl we will treat it as [Cr(H2O)6](3+) for a moment to make things easier.
Now as one H2O is deprotonated [Cr(OH)(H2O)5](2+) forms. Two of them can form a dimer (much like Fe does)
[(H2O)4Cr-(OH)2-Cr(H2O)4](4+) which has two Cr(III) connected by two OH-bridging ligands. So it is not a (OH)2 group but two separate OH(-), I just wasnt sure how to write this here.
Bigger complexes form as more OH(-) is added like [Cr3(OH)4(H2O)9](5+) for example till Cr(OH)3 or [Cr(OH)3(H2O)3] has formed.
All these multinuclear compounds have the Cr(III) octahedrally coordinated by 6 Oxygen atoms. Now the distance of Cr to Cr is quite big and the Cr(III) repel each other. On one hand this kinda distorts the octahedron, on the other hand is this complex just a bridged one and no cluster compound (so no Cr-Cr bond)!
Cr(OH)3 is amphoteric, so it can react with acids to form [Cr(H2O)6](3+) again or with more base to form the [Cr(OH)6](3-). Chromium Chemistry: [Cr(OH)6](3-) and Oxidation to Chromate](https://i.ytimg.com/vi/Of3HUVUGvYM/mqdefault.jpg)

 and equilibrium in water
If you saw our CuCl video we mentioned there that no major reaction happens if a chloride or bromide is added to Copper Sulfate. Some might have seen a minor color change in between and indeed there is a reaction but we didnt want the Cu(I) video to be too confusing so we assumed there that no reaction takes place. For the reduction it does not matter as long as Cu(I) and Cl(-) ions are present the insoluble Cu(I)-Chloride will precipitate. But what if no reducing agent is added ?
As we add Potassium Chloride to a conc. Copper Sulfate solution it turns green. And this is due to the formation of [CuCl4](2-). If you saw our video on Cobalt chemistry we had a similar case there. It is true that a very strong ligand can substitute a weak one but all of these reactions are equilibria. In some cases one side of the equilibrium is favored so we dont see the back reaction. No in aqueous Chloride solution two complexes might form, [Cu(H2O)4](2+) or [CuCl4](2-).
Note: Yes it is an octahedron around Copper but due to Jahn Teller Distortion two axial H2O are further away and [Cu(H2O)4](2+) does exist as ion as well. We use it to have an easier stoichiometry and 1 Chloride will act on 1 Water that way which makes it easier to see.
So the equilibrium is like:
4 Cl(-) + [Cu(H2O)4](2+) to [CuCl4](2-) + 4 H2O
Now lets assume we are on the right side of the equation. In order to to form the blue aqua complex it will have to react with water. Now lets assume we have an excess of Chloride in there which means there is less water in comparison to complex ion and chloride it cant fully go back and thus the equilibrium shifts towards the Chloro-ligand side. We call this Le Chateliers principle.
Now this compound is not green. In fact it is yellow and the green color comes from mixing with the blue aqua-complex which forms as well. To show this we added some HCl to anhydrous CuSO4 (white) to get a beautiful yellow solution containing the yellow [CuCl4](2-). Copper Chemistry: [CuCl4](2-) and equilibrium in water](https://i.ytimg.com/vi/PqD7NW_-CVE/mqdefault.jpg)