Make Small Spindle Sander tubes (for the drill press!) @makethingswithrob
Make Small Spindle Sander tubes (for the drill press!) @makethingswithrob
Uploaded February 2023 | Updated September 2026, 6 hours ago
In this video, we're going to make sandpaper for the drill press. Using dowels, we'll create easy to use sanders to clean the most stubborn radians!

Free step by step instructions/material/tools list → makethingswithrob.com/spindle-sander-small

Become a patron! → Patreon.com/makethings
Thank you to my patrons!

Michelle B
Keith Current
William L McNally
Jerry Adams
Tommy QR
Zach Finch
Rich Lightfoot
Tutor the Barbarian

0:00 Introduction
0:38 1. Materials
1:03 2. Cutting channel
2:26 3. Sandpaper Wrap
3:32 4. Operation
Make Small Spindle Sander tubes (for the drill press!)Make a DRILL PRESS v-block jig for dowelsRatcheting Band Clamp Hack (Better & Cheaper Than Store-Bought!)Tall Fence for the Table Saw: Safer, More Accurate Cuts // The Fence Sleeve OnionMiter Bar Reference Guide // Safer, Repeatable!Make Dovetail Joints with a Bandsaw // Jig + Marker + Directions100 Awl Challenge: Act 5 // The Golden Ratio AwlMake a Yoke Scraper in just an hour! // Step by step buildsTurn Your Router Table Into a Mini JointerZero clearance insert (Table saw) with or without a splitter // Very easy build!Steel Nose Bandsaw SledAdvanced Thicknesser
Lets Make Things |

Make Small Spindle Sander tubes (for the drill press!)

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER