Uploaded March 2024 | Updated November 2026, 4 hours ago
Sponsored by PCBWay.com
I try to build a little circuit that will control a charge/discharge maintenance cycle for my removable EV battery packs when my bike's in long-term storage pending sale.
I turned out to be a marathon not a sprint.
Using A Raspberry Pi, an INA237 power monitor chip, a pair of relays, a pair of MOSFETs (the source of much confusion), the battery's supplied charger and a 100W load. Here's what I did.
Programming was done in Python and is very basic as it's not my normal weapon du choix.
The INA237 chip communicates over I2C and has a trap built in for me!
~~~
PCBWay offer PCB manufacture and assembly, CNC machining, sheet metal fabrication, 3D printing, injection moulding.
Why not check out their extensive community projects section too?
Sponsored by PCBWay.com
I try to build a little circuit that will control a charge/discharge maintenance cycle for my removable EV battery packs when my bike's in long-term storage pending sale.
I turned out to be a marathon not a sprint.
Using A Raspberry Pi, an INA237 power monitor chip, a pair of relays, a pair of MOSFETs (the source of much confusion), the battery's supplied charger and a 100W load. Here's what I did.
Programming was done in Python and is very basic as it's not my normal weapon du choix.
The INA237 chip communicates over I2C and has a trap built in for me!
~~~
PCBWay offer PCB manufacture and assembly, CNC machining, sheet metal fabrication, 3D printing, injection moulding.
Why not check out their extensive community projects section too?

![Building the DFB1r5 Part 2: Acceleration
Continuing the DFB1r5 build. Can we get it to boot today?
Part two of a build series.
https://github.com/dh219/DFB/wiki
https://twitter.com/thetechnoshed
The DFB1 is an in-development open source booster card for the Atari Falcon 030.
Its intended for the release version to have source files for the hardware, the firmware and the supporting software published under the GPL v2.
0:00 Introduction
5:04 Resistor networks
12:00 LEDs
15:10 Testing with the programmer
22:05 Throughhole components
38:16 Flashing the CPLD
43:46 Testing it in the Falcon
[ Obligatory Gadget16UK mention: https://youtu.be/MPWsPKPZxIc?t=18m48s ] Building the DFB1r5 Part 2: Acceleration](https://i.ytimg.com/vi/MPWsPKPZxIc/mqdefault.jpg)








