Uploaded June 2021 | Updated September 2026, 6 minutes ago
I make an Industrial Style Shelf Bracket after bending the Steel Rebar into a knot to use inside the shelf bracket. I love the look of industrial furniture and all the decor that comes with it, and this shelf bracket has the look I like. A nice MIG Welding Project using rebar.
I hope you enjoy my video of the steel rebar knot shelf bracket project. It was a lot of fun to make. I did make other brackets exactly the same, so I could hang the shelves.
The main tools used are a MIG welder, angle grinder, drill, and bench vise.
The big rebar is 12mm, and the small rebar is 7mm
The Brand of the Drill bits and cutting/flap discs is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: https://alphatools.com.au
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely. I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load.
I make an Industrial Style Shelf Bracket after bending the Steel Rebar into a knot to use inside the shelf bracket. I love the look of industrial furniture and all the decor that comes with it, and this shelf bracket has the look I like. A nice MIG Welding Project using rebar.
I hope you enjoy my video of the steel rebar knot shelf bracket project. It was a lot of fun to make. I did make other brackets exactly the same, so I could hang the shelves.
The main tools used are a MIG welder, angle grinder, drill, and bench vise.
The big rebar is 12mm, and the small rebar is 7mm
The Brand of the Drill bits and cutting/flap discs is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: https://alphatools.com.au
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely. I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load.
