Uploaded June 2021 | Updated September 2026, 28 minutes ago
In this video, I make a Steel Knot by Bending Rebar without using heat.
The knot is called a Prusik Knot
This knot will be used in a future Industrial Style project. I love the look of industrial-style furniture, and rebar with knots fits right in with the look I like.
I hope you enjoy my video of the project; it was a lot of fun to make.
The main tools used were a Hammer and a bench vise.
The Brand of the Drill bits and cutting/flap discs is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: https://alphatools.com.au
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely. I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load.
In this video, I make a Steel Knot by Bending Rebar without using heat.
The knot is called a Prusik Knot
This knot will be used in a future Industrial Style project. I love the look of industrial-style furniture, and rebar with knots fits right in with the look I like.
I hope you enjoy my video of the project; it was a lot of fun to make.
The main tools used were a Hammer and a bench vise.
The Brand of the Drill bits and cutting/flap discs is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: https://alphatools.com.au
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely. I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load.
