Uploaded January 2024 | Updated September 2026, 3 hours ago
In this video, I make a Steel Knot Metal Handle which is an Industrial Style Metal Handle, bending rebar to make the Sheepshank knot. I love the look of industrial furniture and all the decor that comes with it, and this rebar handle has the look I like. I hope you enjoy my video of the project, it was a lot of fun to make.
The main tools used, are an LPG Burner, MIG welder, angle grinder, drill, and bench vise.
The Rebar in the handle is 13mm (1/2 inch), The wide flat bar is 75mm wide (3 inches), and 6mm (1/4 inch) thick, The smaller flat bar is 65mm wide (about 2 1/2 inches) and 3mm thick.
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely, I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load.
In this video, I make a Steel Knot Metal Handle which is an Industrial Style Metal Handle, bending rebar to make the Sheepshank knot. I love the look of industrial furniture and all the decor that comes with it, and this rebar handle has the look I like. I hope you enjoy my video of the project, it was a lot of fun to make.
The main tools used, are an LPG Burner, MIG welder, angle grinder, drill, and bench vise.
The Rebar in the handle is 13mm (1/2 inch), The wide flat bar is 75mm wide (3 inches), and 6mm (1/4 inch) thick, The smaller flat bar is 65mm wide (about 2 1/2 inches) and 3mm thick.
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely, I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load.
