Uploaded April 2026 | Updated September 2026, 2 weeks ago
This time I'm trying something completely different.
Help support this channel! patreon.com/Needitmakeit
Use Coupon NM100 for $100 off of a 1200Watt Metal Fab or Bundle
xtool.com/products/xtool-metalfab-laser-welder-and-cnc-cutters?ref=mqxcefeo&utm_medium=affiliate&utm_source=goaffpro&utm_term=5306
A short list to help support this channel, thank you so much for your help!
Bambu H2C - tidd.ly/3K3sSY9 (If you print with color, this is the way)
Bambu P2S - tidd.ly/3ISZkfq (Best value)
Bambu H2S - tidd.ly/4olSRbL (Most options for money)
Bambu H2D - tidd.ly/4q9RsHk (A dual color beast)
Bambu Filament Shown in Videos - tidd.ly/4hn6TYI
Rode Wireless ME mic (Saved me about 4+ hours/vid) - amzn.to/3vcMKAr
Mag clip (Super handy, but a little pricy) - amzn.to/3NBFvZe
This project took me longer to design than it did to build. It came together really well, I was surprised how little adjusting I needed to make, especially considering that there ended up being 38 parts all coming together. I did have a few issues with assembly, mainly the fact that I ended up welding parts together that I didn't plan on, and after some careful small adjustments, I had something that worked... well it worked, but not quite like how I was expecting it to. This is a great practical project, a good challenge and these ideas can be improved more for even better results.
#xtool
#3dprinting
#woodstove
#diy
This time I'm trying something completely different.
Help support this channel! patreon.com/Needitmakeit
Use Coupon NM100 for $100 off of a 1200Watt Metal Fab or Bundle
xtool.com/products/xtool-metalfab-laser-welder-and-cnc-cutters?ref=mqxcefeo&utm_medium=affiliate&utm_source=goaffpro&utm_term=5306
A short list to help support this channel, thank you so much for your help!
Bambu H2C - tidd.ly/3K3sSY9 (If you print with color, this is the way)
Bambu P2S - tidd.ly/3ISZkfq (Best value)
Bambu H2S - tidd.ly/4olSRbL (Most options for money)
Bambu H2D - tidd.ly/4q9RsHk (A dual color beast)
Bambu Filament Shown in Videos - tidd.ly/4hn6TYI
Rode Wireless ME mic (Saved me about 4+ hours/vid) - amzn.to/3vcMKAr
Mag clip (Super handy, but a little pricy) - amzn.to/3NBFvZe
This project took me longer to design than it did to build. It came together really well, I was surprised how little adjusting I needed to make, especially considering that there ended up being 38 parts all coming together. I did have a few issues with assembly, mainly the fact that I ended up welding parts together that I didn't plan on, and after some careful small adjustments, I had something that worked... well it worked, but not quite like how I was expecting it to. This is a great practical project, a good challenge and these ideas can be improved more for even better results.
#xtool
#3dprinting
#woodstove
#diy
