Uploaded October 2018 | Updated November 2026, 17 hours ago
After making my brass handled marking knife I decided it needed a box. Something that was on the nicer side. And after thinking about it for a few days I came up with this simple box design. Its fairly simple but what I think makes it unique is the brass hinge. I discovered that I could peen over the two ends of a brass rod and create a simple and clean hinge. Peening the ends flares them out and acts not only as the hinge but also keeps the lid on the box.
One thing I realized after making this is that I could have probably used a scroll saw to cut out the silhouette of the knife instead of routing it out. I would have just had to cut the bottom section in to two pieces. If I make another one I will try this method instead to see if its any quicker to make.
After making my brass handled marking knife I decided it needed a box. Something that was on the nicer side. And after thinking about it for a few days I came up with this simple box design. Its fairly simple but what I think makes it unique is the brass hinge. I discovered that I could peen over the two ends of a brass rod and create a simple and clean hinge. Peening the ends flares them out and acts not only as the hinge but also keeps the lid on the box.
One thing I realized after making this is that I could have probably used a scroll saw to cut out the silhouette of the knife instead of routing it out. I would have just had to cut the bottom section in to two pieces. If I make another one I will try this method instead to see if its any quicker to make.










