Uploaded September 2020 | Updated September 2026, 48 minutes ago
Available soon at belnapcustomknives.com
The Multi Guide Pro has a well established history and is a mature design with many capabilities demonstrated and many more capabilities yet to be uncovered. The latest redesign is a major leap forward in terms of quality and increased utility over the previous version.
Blank material 80crv2 post heat treat.
I give a detailed demonstration how I setup the Multi Guide Pro and Heretic H2 Sander for bevel grinding.
00:00 Discuss planned bevel grind
00:12 Showing the bevel setting calculation and values
00:55 Square the Multi Guide Pro to the platen
01:45 Set the bevel grind angle by rotating platen
03:14 Set Multi Guide Pro throat spacing and positioning the shelf plate for the blank carrier to ride on
04:30 Mark the plunge line on the blank
05:30 Clamp blank to carrier blank
06:36 Set divider to desired bevel height
06:40 Install 80 grit belt on machine
07:14 Discuss in detail function of bevel guide and blank carrier
08:50 Begin bevel grind
09:30 Set position of the plunge
10:30 Bevel grinding
10:50 Show progress of bevel
11:35 Show progress of bevel
12:10 Check progress with dividers
12:45 Begin targeted grind technique along middle section of bevel to raise it up to match tip
13:40 Check progress with dividers and discuss targeted grind plan
14:20 Begin targeted grind at the rear of the bevel
14:40 Show finished bevel at 80 grit
14:50 Change belt to 400 grit and begin targeted grind of the tip of the bevel
17:53 Setup and cut the plunge that I forgot to do prior to doing the 400 grit finish. Then camera battery died.
Available soon at belnapcustomknives.com
The Multi Guide Pro has a well established history and is a mature design with many capabilities demonstrated and many more capabilities yet to be uncovered. The latest redesign is a major leap forward in terms of quality and increased utility over the previous version.
Blank material 80crv2 post heat treat.
I give a detailed demonstration how I setup the Multi Guide Pro and Heretic H2 Sander for bevel grinding.
00:00 Discuss planned bevel grind
00:12 Showing the bevel setting calculation and values
00:55 Square the Multi Guide Pro to the platen
01:45 Set the bevel grind angle by rotating platen
03:14 Set Multi Guide Pro throat spacing and positioning the shelf plate for the blank carrier to ride on
04:30 Mark the plunge line on the blank
05:30 Clamp blank to carrier blank
06:36 Set divider to desired bevel height
06:40 Install 80 grit belt on machine
07:14 Discuss in detail function of bevel guide and blank carrier
08:50 Begin bevel grind
09:30 Set position of the plunge
10:30 Bevel grinding
10:50 Show progress of bevel
11:35 Show progress of bevel
12:10 Check progress with dividers
12:45 Begin targeted grind technique along middle section of bevel to raise it up to match tip
13:40 Check progress with dividers and discuss targeted grind plan
14:20 Begin targeted grind at the rear of the bevel
14:40 Show finished bevel at 80 grit
14:50 Change belt to 400 grit and begin targeted grind of the tip of the bevel
17:53 Setup and cut the plunge that I forgot to do prior to doing the 400 grit finish. Then camera battery died.
