Uploaded August 2020 | Updated September 2026, 2 hours ago

---

I change bevel angle from 2.9 degrees to 3.0 degrees to bring the upper bevel line down from the spine.
00:00 Zero machine then set bevel angle to 3 degrees.
02:37 Show surface ground blank and discuss how I plan to perform the grind.
02:54 Making the plunge target lines on the blank using the Plunge Stop tool.
03:33 Begin bevel grind.
04:44 Show bevel progress.
05:05 Showing effect of bowed blank on bevel grind and describe how I plan to grind.
09:20 Showing progression of grind and difference caused in grind by bowed blank.
13:44 Evening out the bowed effect of the blank so the bevel is even and cutting edge is uniform thickness.
16:30 Demonstrate how to cut the plunge line.
18:55 Change belts to a 400 grit for final finish grind.