Uploaded June 2021 | Updated September 2026, 1 week ago
In the previous 7 videos in the Uart side project we have designed and built the circuit for a single speed Uart with receive and transmit fifos. In this video I transcribe the last section to pcb and put it all together.
The achievement is marred a little by an error on the silk screen. I'll decide if I'll do a new board revision or just print out a label to stick over it at a later point.
0:00 Introduction
1:14 Schematic
12:42 Layout
15:12 Routing
18:32 Unbox
21:55 Hot-Air
25:57 Test
In the previous 7 videos in the Uart side project we have designed and built the circuit for a single speed Uart with receive and transmit fifos. In this video I transcribe the last section to pcb and put it all together.
The achievement is marred a little by an error on the silk screen. I'll decide if I'll do a new board revision or just print out a label to stick over it at a later point.
0:00 Introduction
1:14 Schematic
12:42 Layout
15:12 Routing
18:32 Unbox
21:55 Hot-Air
25:57 Test
