Uploaded May 2026 | Updated September 2026, 2 weeks ago
Ever make your own molding on the table saw?
Back when I got started in the ’80s, we probably made 90% of our molding profiles on the saw. I’m still using the same cutter head today.
This 3/4” bead profile was made for the apron of an outdoor table I built back in 2018. The legs came from @vandykesrestorers and earlier this week I gave the top a fresh coat of @totalboat Gleam spar varnish.
Almost 8 years later, living outside at the Jersey Shore, and this table is still holding up. See less
Ever make your own molding on the table saw?
Back when I got started in the ’80s, we probably made 90% of our molding profiles on the saw. I’m still using the same cutter head today.
This 3/4” bead profile was made for the apron of an outdoor table I built back in 2018. The legs came from @vandykesrestorers and earlier this week I gave the top a fresh coat of @totalboat Gleam spar varnish.
Almost 8 years later, living outside at the Jersey Shore, and this table is still holding up. See less
