Uploaded December 2022 | Updated September 2026, 5 hours ago

---

Putting holes and threads into POM cuboids to turn them into side parts …
↓↓↓ Complete description, time index and links below ↓↓↓

In the previous video we’ve milled two POM stock blocks down to the required dimensions (link below). Now we just have to drill five holes (two 6mm, two 5mm and one 12mm) and cut two M6 threads into each of our side parts.

We start by reviewing the detailed drawing and mark the required lines on our work piece. Then we drill the two 6mm holes. The 12mm hole is drilled in several steps. Finally we drill the two 5mm holes and cut M6 threads into them.

00:00 Intro – time to make some holes
00:33 Detailed drawing – just a short recap
01:28 Marked – the two side parts
04:38 Drilled (1) – two 6mm holes
07:30 Drilled (2) – one 12mm hole in 3 steps
10:39 Drilled (3) – two 5mm holes
13:02 Cut – two M6 threads
14:23 Wrap-up – next time we turn again, bye

Dual Electronic Engine Control Lever IP68 youtube.com/playlist?list=PLwq-2MnM58FLQ468e5-wzV6_MeqT4Zd5T
Dual Electronic Engine Control Lever IP68 (1): Project Kick-Off youtu.be/hPBkBoe81jY
Dual Electronic Engine Control Lever IP68 (2): 1st LEGO® Technic™ Prototype youtu.be/rH1zjXptJrg
Dual Electronic Engine Control Lever IP68 (3): LEGO® Model, PCB Layout, Friction youtu.be/XZdhH0JCDWA
Dual Electronic Engine Control Lever IP68 (4): First Drawing, Final PCB Layout youtu.be/PJBEf1LOwcY
Dual Electronic Engine Control Lever IP68 (5): Handles youtu.be/7WoETltnHtY
Dual Electronic Engine Control Lever IP68 (6): Levers (1) youtu.be/UZPrt9G_c_0
Dual Electronic Engine Control Lever IP68 (7): Levers (2) youtu.be/l_Xy6iEkE9A
Dual Electronic Engine Control Lever IP68 (8): PCB youtu.be/DrBdqCAIHag
Dual Electronic Engine Control Lever IP68 (9): Side Parts (1) youtu.be/cy7NFNoStaY

#throttle #lever #ip68 #robertssmorgasbord