Uploaded December 2023 | Updated September 2026, 11 hours ago
First go with thread chasing!
Four walnut blanks glued up and box turned. Used a jig and setup based on the method shown by Alan Stratton from As Wood Turns (link below). Used a 3/4” by 10 tpi, instead of the
16 tpi he shows. 5-11/32” tall by 3-5/8” diameter. Lid is 1-5/8” tall. Sanded to 400 grit then Ack’s abrasive past. Finished with Ack’s carnauba wax.
DIY Threading Jig For Common Wood by Alan Stratton (@AsWoodTurns)
youtu.be/oAcgfq_WthM?si=Svtac4QHe_3jWkGp
First go with thread chasing!
Four walnut blanks glued up and box turned. Used a jig and setup based on the method shown by Alan Stratton from As Wood Turns (link below). Used a 3/4” by 10 tpi, instead of the
16 tpi he shows. 5-11/32” tall by 3-5/8” diameter. Lid is 1-5/8” tall. Sanded to 400 grit then Ack’s abrasive past. Finished with Ack’s carnauba wax.
DIY Threading Jig For Common Wood by Alan Stratton (@AsWoodTurns)
youtu.be/oAcgfq_WthM?si=Svtac4QHe_3jWkGp
