Uploaded September 2023 | Updated September 2026, 25 minutes ago
Bending Flat Bar into Rings using a Hammer and Rail Track - 50mm x 6mm (2" x 1/4" )Flat bar.
I am making these flat bar rings as I needed the rings to put on some steel wheel hubs I have made, this will give the project the exact look I wanted, although I do not make the wheels in the video, there is a photo of the finished wheel, at the end of the video.
I just love the rustic look of hammered metal, it goes very well with the other thing I like, Rebar.
The Flat Bar is 50mm x 6mm (2" x 1/4" )
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely, I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
Bending Flat Bar into Rings using a Hammer and Rail Track - 50mm x 6mm (2" x 1/4" )Flat bar.
I am making these flat bar rings as I needed the rings to put on some steel wheel hubs I have made, this will give the project the exact look I wanted, although I do not make the wheels in the video, there is a photo of the finished wheel, at the end of the video.
I just love the rustic look of hammered metal, it goes very well with the other thing I like, Rebar.
The Flat Bar is 50mm x 6mm (2" x 1/4" )
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely, I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
